Fujitsu ETERNUS DX Disk Panduan Konfigurasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 44 halaman. Server connection, fcoe for linux driver settings for converged network adapter cards
Juga untuk Fujitsu ETERNUS DX Disk: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (29 halaman), Panduan Konfigurasi (25 halaman), Panduan Konfigurasi (32 halaman), Panduan Konfigurasi (35 halaman), Panduan Konfigurasi (31 halaman), Panduan Konfigurasi (43 halaman), Panduan Konfigurasi (21 halaman), Panduan Konfigurasi (24 halaman)

Fujitsu ETERNUS DX Disk Panduan Konfigurasi
Chapter 1
Workflow
1.4
For QLogic Drivers
Setting Up the Fibre Channel Switches
If a Fibre Channel switch is to be used, set it up now.
"Chapter 6 Setting Up the Fibre Channel Switches" (page 34)
Setting up the Fibre Channel switches
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre
-
Channel Switch Settings"
Checking the Fibre Channel switch connection requirements
"Server Support Matrix for FC-SWITCH"
-
Installing the Driver
Install the appropriate driver for the Fibre Channel card being used.
"Chapter 7 Installing Drivers and Setting Up the Server" (page 36)
Installing Fibre Channel cards and drivers
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle
-
Solaris Driver Settings for Non-Fujitsu Fibre Channel Cards"
Checking the Fibre Channel card driver versions
"Server Support Matrix"
-
Setting Up the Server
Edit the setup file (/kernel/drv/qla2300.conf) to set the parameters required for connection.
"Chapter 7 Installing Drivers and Setting Up the Server" (page 36)
Setting up the server
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle
-
Solaris Driver Settings for Non-Fujitsu Fibre Channel Cards"
Setting Up the Server to Recognize the Logical Units and Labeling LUN (sd Driver)
Edit the setup file (/kernel/drv/sd.conf) to allow the sd driver to recognize the ETERNUS DX storage sys-
tems' logical units. Then, label the LUNs using the "format" command.
Setting up the server
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle
-
Solaris Driver Settings for Non-Fujitsu Fibre Channel Cards"
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
18
Copyright 2015 FUJITSU LIMITED
P3AM-3702-16ENZ0