Fujitsu ETERNUS DX Disk Panduan Konfigurasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 35 halaman. Server connection, fcoe for linux driver settings for converged network adapter cards
Juga untuk Fujitsu ETERNUS DX Disk: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (44 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (29 halaman), Panduan Konfigurasi (25 halaman), Panduan Konfigurasi (32 halaman), Panduan Konfigurasi (31 halaman), Panduan Konfigurasi (43 halaman), Panduan Konfigurasi (21 halaman), Panduan Konfigurasi (24 halaman)

Fujitsu ETERNUS DX Disk Panduan Konfigurasi
Chapter 1
Setup Procedure for Emulex Converged Network Adapter Cards
1.2
Setting Up the Converged Network Adapter Cards
The following shows an example of this.
Host name
IP Address
Physical slot
name
slot0
Details of contents
The details of contents for the WWN instance management table for the server are as follows:
Host name:
Record the host name.
IP Address:
Record the IP address of the server.
Physical slot name:
Record the slot position of installed Converged Network Adapter card.
Converged Network Adapter card WWN:
Record the value of [Port Name].
Instance name:
Not necessary to record.
Physical address:
Record the value of [Mem Base].
Cable tag:
Record a tag name which indicates the connection path (relationship between the connected device
and the port).
6
Press the [Esc] key to quit the Emulex OneConnect FCoE BIOS Utility.
When installing two or more Converged Network Adapter cards to the server, first turn off the server,
then repeat
If multiple Converged Network Adapter cards are already installed in the server at the time of pur-
chase, the one-to-one relationship between the WWNs and the Converged Network Adapter cards
cannot be recognized. The WWNs that are obtained in this section may need to be repeatedly regis-
tered and set up on the ETERNUS DX until a server recognizes the ETERNUS DX logical disks.
For details about ETERNUS DX settings, refer to "FUJITSU Storage ETERNUS DX Configuration Guide -
Server Connection- Disk Storage System Settings" that corresponds to the ETERNUS DX to be connec-
ted.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for VMware
Server#1
192.168.0.10
Converged Network Adapter
card WWN
10 00 00 00 C9 D0 43 DD
Step 1
through
Step 5
shown here for each Converged Network Adapter card to be installed.
Copyright 2015 FUJITSU LIMITED
Instance name
Physical address
CD4C0000
9
Cable tag
SERV1_SLOT0 to SWITCH_1_port0
®
ESX
P3AM-4772-11ENZ0