Fujitsu ETERNUS DX Disk Panduan Konfigurasi - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX Disk. Fujitsu ETERNUS DX Disk 21 halaman. Server connection, fcoe for linux driver settings for converged network adapter cards
Juga untuk Fujitsu ETERNUS DX Disk: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (44 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (29 halaman), Panduan Konfigurasi (25 halaman), Panduan Konfigurasi (32 halaman), Panduan Konfigurasi (35 halaman), Panduan Konfigurasi (31 halaman), Panduan Konfigurasi (43 halaman), Panduan Konfigurasi (24 halaman)

Chapter 1

Setup Procedure for Emulex Converged Network Adapter Cards

1.5

Creating an Initial RAM Disk

Use the value of "8" if the actual result is lower. Use the maximum value if the actual result exceeds

the maximum value for the driver.

To achieve maximum system performance, this value can be changed according to the server load

and the peak operating times.

The number of simultaneous command executions per CA port for the ETERNUS DX is limited to

1024. This value is used by multiple servers that share the CA port. A maximum of 1024 commands

can be executed per CA port.

1.5

Creating an Initial RAM Disk

Create an initial RAM disk image file to match the kernel being used. Refer to the Emulex Converged Network

Adapter card manual for details on the creation method.

1.6

Reboot the OS. When the Converged Network Adapter card requires a non-standard driver, check the files in

"/var/log/messages" and confirm that the correct version of the Converged Network Adapter card driver has

been installed after rebooting the OS.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for Linux

P3AM-6402-11ENZ0