Fujitsu ETERNUS DX100 S3 Panduan Konfigurasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX100 S3. Fujitsu ETERNUS DX100 S3 13 halaman. Hybrid storage systems, all-flash arrays, power synchronized unit
Juga untuk Fujitsu ETERNUS DX100 S3: Konfigurasi Manual Koneksi Server (12 halaman), Konfigurasi Manual Koneksi Server (12 halaman), Panduan Konfigurasi (28 halaman), Setup Manual (15 halaman), Tindakan Pencegahan Keselamatan (12 halaman)

Chapter 2

Setting Up the ETERNUS DX

2.1

Common Settings

Parameter

Transfer Rate

Frame Size

Reset Scope

Release Reservation if Chip is Reset

*1: Set the appropriate value from the following table.

Fibre Channel switch maximum

speed

16Gbit/s

8Gbit/s

4Gbit/s

*1: Specify "Auto Negotiation" for direct connections to 16Gbit/s Brocade Fibre Channel cards.

Make sure to prepare and set up Fibre Channel switches for Fibre Channel connections. For setting details,

refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Chan-

nel Switch Settings" or "Fabric OS Administrator's Guide Supporting Fabric OS".

2.1.2

Creating the Server Accessible LUN Groups (Setting the LUN Groups)

Create LUN groups for the server to access. Refer to "Connectivity Management" in "ETERNUS Web GUI User's

Guide" for details, and set the LUN groups.

Depending on the OS version, the server may not recognize the ETERNUS DX unless a LUN group is as-

signed from LUN0. In this case, assign a LUN group starting from LUN0 in ascending order.

Transfer rate setting value

16Gbit/s CA

16Gbit/s (*1)

8Gbit/s

4Gbit/s

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

Setting value

See the table below (*1)

2048

I_T_L

Disable

8Gbit/s CA

8Gbit/s

4Gbit/s

P3AM-7962-08ENZ0