Fujitsu ETERNUS DX410 Panduan Pengguna - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyimpanan Fujitsu ETERNUS DX410. Fujitsu ETERNUS DX410 42 halaman. Server connection, (iscsi) for hp-ux
Juga untuk Fujitsu ETERNUS DX410: Panduan Pengguna (35 halaman), Panduan Konfigurasi (28 halaman)

Halaman Cetak

Chapter 6

Setting Up the VMware ESX Server

This chapter describes settings related to the server iSCSI interface.

6.1

For VMware vSphere

Set up the VMware ESX server using the vSphere Client. The procedures described here are based on the fol-

lowing multipath configuration.

●

For the ETERNUS DX Disk storage system

For example, a total of four IP addresses are required by the following iSCSI connection setup.

Example connection configuration

VMkernel (iSCSI Software Initiator)

IP address (1)

IP address

for iSCSI port (3)

6.1.1

Turning on the Devices

To turn on the connected devices, use the following procedures:

Turn on the LAN switch power.

Check that the LAN switch's Ready (or equivalent) LED is lit.

Turn on the ETERNUS DX Disk storage system.

Check that the Ready LED is lit on the ETERNUS DX Disk storage system.

ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware

VMware ESX server

LAN card

LAN switch

ETERNUS DX Disk storage system

VMkernel (iSCSI Software Initiator)

IP address (2)

LAN card

LAN switch

IP address

for iSCSI port (4)

ESX

P3AM-3412-13ENZ0