Fujitsu ETERNUS DX410 Panduan Konfigurasi - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu ETERNUS DX410. Fujitsu ETERNUS DX410 28 halaman. Server connection, (iscsi) for hp-ux
Juga untuk Fujitsu ETERNUS DX410: Panduan Pengguna (35 halaman), Panduan Pengguna (42 halaman)
Halaman Cetak
Chapter 6
Installing the iSCSI Software Initiator and Setting Up the Server
6.2
Setting Up the Server
3
Confirm the iSCSI Initiator name.
Use the "iscsiutil" command to check the iSCSI Initiator name.
The iSCSI Initiator name shown here is used for the ETERNUS DX settings.
# iscsiutil -l
4
Save the statically-recognized iSCSI target information in the kernel registry.
Use the "iscsiutil" command to save the iSCSI target information.
# iscsiutil [iscsi-device-file] -a -I <ip-address>
Example:
For an ETERNUS DX with a connection target iSCSI port IP address of 192.1.1.120:
# iscsiutil -a -I 192.1.1.120
5
Confirm the iSCSI target information is now in the kernel registry.
# iscsiutil -p -D
6
Set whether CHAP authentication is to be used or not.
If CHAP authentication is to be performed, set "CHAP". If CHAP authentication is not required, set
"None".
Example:
When CHAP authentication is not used:
# iscsiutil -t authmethod None
Note:
# iscsiutil -t authmethod CHAP None
The above command sets CHAP authentication to operate according to the ETERNUS DX setting. The
CHAP authentication method is selected if the ETERNUS DX uses CHAP for its responses, otherwise CHAP
authentication is not performed.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX
[-P <tcp-port>][-M <portal-grp-tag>]
18
Copyright 2014 FUJITSU LIMITED
P3AM-3402-14ENZ0