Fujitsu Eternus DX600 S3 Panduan Konfigurasi - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Penyimpanan Fujitsu Eternus DX600 S3. Fujitsu Eternus DX600 S3 28 halaman. Hybrid storage systems, all-flash arrays, power synchronized unit
Juga untuk Fujitsu Eternus DX600 S3: Konfigurasi Manual Koneksi Server (12 halaman), Panduan Konfigurasi (13 halaman), Panduan Konfigurasi (18 halaman), Tindakan Pencegahan Keselamatan (12 halaman)
Halaman Cetak
Chapter 4
Checking the Server Information
The server information registered in the ETERNUS DX should be checked.
A variety of commands are used to check the following server information.
iSCSI initiator name
•
Execute the following command:
iscsiutil -l
The iSCSI initiator name is displayed in the "Initiator Name" column.
Server-side LAN card IP address for connecting to the ETERNUS DX
•
Execute the following command:
ifconfig
Set this IP address if it is not already set.
Initiator CHAP Name
•
The Initiator CHAP Name is the user name for unidirectional CHAP authentication. Execute the following
command:
This is not required if CHAP authentication is not used.
iscsiutil -pD
The Initiator CHAP Name is displayed in the "Initiator CHAP Name" column of the applicable target infor-
mation.
CHAP Secret
•
The CHAP Secret is the password for unidirectional CHAP authentication. Execute the following command:
This is not required if CHAP authentication is not used.
iscsiutil -pD
The CHAP Secret is displayed in the "CHAP Secret" column of the applicable target information.
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX
13
Copyright 2014 FUJITSU LIMITED
P3AM-3402-14ENZ0