Fujitsu ETERNUS DX8700 S2 Panduan Pengguna - Halaman 34
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penyimpanan Fujitsu ETERNUS DX8700 S2. Fujitsu ETERNUS DX8700 S2 42 halaman. Disk storage system settings
Juga untuk Fujitsu ETERNUS DX8700 S2: Panduan Pengguna (35 halaman), Panduan Konfigurasi (28 halaman), Panduan Konfigurasi (15 halaman)
Halaman Cetak
Chapter 6
Setting Up the VMware ESX Server
6.2
For VMware Infrastructure 3
6.2.4
Setting the Software Initiator
Enable Software Initiator in VMware ESX.
1
Select the [Configuration] tab on VMware Infrastructure Client and click [Storage Adapters].
2
Select the target iSCSI Software Adapter and click [Properties].
3
Click [Configure] on the [General] tab.
4
Select the [Status-Enabled] checkbox and click the [OK] button.
5
Confirm that the [Enabled] checkbox is selected under "Status" on the [General] tab and click [Config-
ure] again.
6
Confirm that the iSCSI name is displayed as follows and click the [Cancel] button.
7
Select the [Dynamic Discovery] tab and click the [Add] button.
8
Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk storage system as the iSCSI
server IP address, confirm that the port is set to "Port 3260" (default), and click the [OK] button.
ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware
34
Copyright 2013 FUJITSU LIMITED
®
ESX
P3AM-3412-13ENZ0