Fujitsu ETERNUS2000 model 100 Manual Koneksi - Halaman 25
Jelajahi secara online atau unduh pdf Manual Koneksi untuk Penyimpanan Fujitsu ETERNUS2000 model 100. Fujitsu ETERNUS2000 model 100 31 halaman. Disk storage system
Juga untuk Fujitsu ETERNUS2000 model 100: Manual (28 halaman), Manual Koneksi Server (25 halaman), Manual Koneksi Server (32 halaman), Manual Koneksi (19 halaman)
Halaman Cetak
Chapter 10 Setting Up and Checking the device-mapper multipath
>
10.2 For SLES
10.1.5
Checking the device-mapper multipath Status and Created Devices
Check the path status using the "multipath -ll" command.
•
When both paths are in normal status (This example is for the ETERNUS2000)
The multipath consists of the block device
names "sde" and "sdc". "mpath2" is created.
# multipath -ll
mpath2 (3600000e00d00000000000f7e00010000) dm-1 FUJITSU,E2000
[size=10G][features=1 queue_if_no_path][hwhandler=0][rw]
\_ round-robin 0 [prio=50][active]
\_ 4:0:0:1 sde 8:64 [active][ready]
\_ round-robin 0 [prio=10][enabled]
\_ 3:0:0:1 sdc 8:32 [active][ready]
:
:
10.2
For SLES
10.2.1
Editing "/etc/multipath.conf"
Edit the "/etc/multipath.conf" device-mapper multipath configuration file as follows:
Procedure
1
2
P3AM-4212-02ENZ0
ETERNUS2000 Disk storage systems Server Connection Guide (SAS) for Linux
Two block device names are
displayed for a two-path configuration.
Copy the "/usr/share/doc/packages/multipath-tools/multipath.conf.synthetic" file
to "/etc".
# cp /usr/share/doc/packages/multipath-tools/multipath.conf.synthetic
/etc/multipath.conf
Add the following lines to the file.
Add the following lines at the end of the "defaults" section.
defaults{
user_friendly_names yes
}
"E2000" is displayed since the
ETERNUS2000 is connected.
When the path status is normal,
"[active][ready]" is displayed.
25
Copyright 2010 FUJITSU LIMITED