Fujitsu ETERNUS4000 600 Manual - Halaman 17

Jelajahi secara online atau unduh pdf Manual untuk Penyimpanan Fujitsu ETERNUS4000 600. Fujitsu ETERNUS4000 600 28 halaman. Disk storage systems (fibre channel) for oracle solaris
Juga untuk Fujitsu ETERNUS4000 600: Manual (21 halaman), Manual Koneksi Server (25 halaman), Manual Koneksi Server (32 halaman), Manual Koneksi (19 halaman)

Halaman Cetak

Chapter 7 Installing the iSCSI Software Initiator and Setting Up the Server

7.2 Setting Up the Server

7.2.2

iSCSI Basic Settings

The following operations are required for iSCSI connection.

•

Checking the iSCSI Initiator

•

Checking the iSCSI Initiator Node Name

•

Setting the iSCSI Target IP addresses

•

Enabling the iSCSI Target connection

•

Creating an iSCSI device link

•

Checking the ETERNUS Disk storage system

Procedure

P3AM-4182-03ENZ0

Server Connection Guide (iSCSI) for Oracle Solaris

Check that the iSCSI Initiator service (iscsid) is enabled.

# svcs -a | grep iscsi

disabled

14:30:33

If the iSCSI Initiator service is "disabled" (the default setting), use the "svcadm" command

to change it to the "online" state.

# svcadm enable iscsi/initiator

# svcs -a | grep iscsi

disabled

14:30:33 svc:/system/iscsitgt:default

online

14:30:33 svc:/network/iscsi/initiator:default

Check the iSCSI Initiator Node Name.

Use the "iscsiadm" command to check the iSCSI Initiator Node Name.

This name is used for the ETERNUS Disk storage system settings.

# iscsiadm list initiator-node

Initiator node name: iqn.1986-03.com.sun:01:0003bace9997.48a386c4

Initiator node alias: -

Header Digest: NONE/-

Data Digest: NONE/-

Authentication Type: NONE

RADIUS Server: NONE

Configured Sessions: 1

Set the iSCSI Target IP address(es).

To connect the iSCSI Target, specify the IP address of each iSCSI CA port of the

ETERNUS Disk storage system that is to be an iSCSI Target, as a "discovery-address".

# iscsiadm add discovery-address

svc:/network/iscsi/initiator:default

IP_address