AEG ARCTIS Panduan Petunjuk Pengoperasian - Halaman 35

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kulkas AEG ARCTIS. AEG ARCTIS 40 halaman. Built-in fridge-freezers
Juga untuk AEG ARCTIS: Panduan Petunjuk Pengoperasian (32 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Pengoperasian (36 halaman), Panduan Petunjuk Pengoperasian (36 halaman), Panduan Petunjuk Pengoperasian (26 halaman), Petunjuk Pengoperasian & Panduan Pemasangan (28 halaman), Panduan Petunjuk Pengoperasian (36 halaman), Panduan Petunjuk Pengoperasian (27 halaman), Panduan Petunjuk Pengoperasian (34 halaman), Panduan Pengguna (24 halaman), Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Pengoperasian (29 halaman), Panduan Petunjuk Pengoperasian (23 halaman), Panduan Petunjuk Instalasi (25 halaman), Panduan Petunjuk Instalasi (24 halaman)

AEG ARCTIS Panduan Petunjuk Pengoperasian
Malfunction
Red warning indicator is
flashing, temperature dis-
play shows a square or
error code (F7 or F8).
The freezer compartment
temperature is insufficient.
Interior illumination does
not function.
If the door remains open
for more than 5 minutes,
the interior illumination
blinks and is switched off
after.
Large accumulation of
frost in the appliance,
perhaps also at the door
seal.
Possible cause
A functions error has
occurred.
The appliance is in the
operation mode "Cooling"
instead of "Freezing".
Temperature is not properly
adjusted.
Door was open for a long
time.
Within the last 24 hours a
large quantity of warm
foods were loaded.
Appliance is next to a
source of warmth.
Light bulb is defective.
This is normal, no error has
occurred.
Door is not properly sealed
(perhaps after reversing
door).
What to do if ...
Remedy
Please make a note of the
indicated error and inform
the customer service
department. Do not open
the appliance door again.
Switching the appliance in
the operation mode
"Freezing". For that, please
refer in the "Select
Freezing or Cooling"
chapter.
Please refer to the section
"Temperature Adjustment".
Only leave the door open
as long as necessary.
Press FROSTMATIC button.
Please refer to the section
"Installation Location".
Please refer in this chapter
under "Replace light bulb" .
Please refer to "Interior
Illumination" section.
Carefully warm the door
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the
warmed door seal by hand,
so that it is again properly
seated.
35