AEG OKO-SANTO 1454-6 iU Petunjuk Pengoperasian dan Pemasangan - Halaman 17
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kulkas AEG OKO-SANTO 1454-6 iU. AEG OKO-SANTO 1454-6 iU 28 halaman. Built-in refrigerator
Halaman Cetak
Starting up and temperature regulation
Connect the appliance to the mains electricity supply.
When the refrigerator compartment door is opened, the internal light-
ing is switched on.
The temperature selector knob is located on the right hand side of the
refrigerator compartment.
Setting "0" means: Off.
Turning clockwise in direction "1":
Refrigerating unit on, the latter then
operates automatically.
Setting "1" means:
Hightest temperature, warmest set-
ting.
AEG62
Setting "6" (end-stop) means:
Lowest temperature, coldest setting.
The temperatures in the refrigerator compartment and freezer com-
partment cannot be independently regulated.
At a low ambient temperature of around 16°C, setting "1" should be
selected. At ambient temperatures of around 25°C, select setting "2".
If you require a lower temperature, select setting "3" or "4". On this
setting , you can be sure the fresh food placed in the freezer compart-
ment will be reliably frozen and that a storage temperature of -18°C
will be maintained in the freezer compartment.
If you want to freeze fresh food rapidly, select setting "6", ensuring
that the temperature in the refrigerator compartment does not drop
below 0°C. You should also promptly reset the thermostat knob to set-
ting "3" or "4" after the freezing of the fresh food is complete.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold set-
ting on the thermostat (position"5" to "6") can cause the compressor
to run continuously.
Reason: when the ambient temperature is high, the compressor must
run continuously to maintain the low temperature in the appliance.
The fridge will not be able to defrost since automatic defrosting of the
fridge is only possible when the compressor is not running (see also
"Defrosting" section). The result is the build up of a thick layer of frost
on the fridge rear wall.
If this happens, turn the thermostat knob back to a warmer setting
(position "3" to "4"). At this setting the compressor will be switched on
and off as usual and automatic defrosting recommenced.
17