Fujitsu SCANPARTNER 600C Panduan Pengguna - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer Fujitsu SCANPARTNER 600C. Fujitsu SCANPARTNER 600C 25 halaman. Image scanner
Juga untuk Fujitsu SCANPARTNER 600C: Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai (7 halaman), Prosedur Instalasi (5 halaman), Panduan Pengguna (23 halaman)

4. Troubleshooting

The scanner will automatically perform a simple self-test

each time it is turned on. This will help spot major system

errors in the scanner itself.

When the self test is initiated, the ERROR LED will become

lit and will remain lit for the duration of the test. When the

test is complete, the ERROR LED light will go out.

If you have problems with the operation of your scanner,

please check the following troubleshooting hints.

Question: The LED indicates that the scanner is ready,

but the scanner does not respond to the scan

command from the host computer.

Answer:

Please check the signal cable is firmly seated,

and invoke the scan command again. If there is

still no response, please reset the scanner by

turning it off and then on again, and reboot your

host computer as well.

Question: Paper becomes jammed during scanning.

Answer:

Open the ADF unit and carefully pull out the

jammed document

Question: More than one sheet of paper was fed into the

scanner.

Answer:

1) Open ADF unit.

2) Remove the multi-fed sheets of paper.

3) Close the ADF unit.

4) Flatten the corners and edges; loosen the

paper before reloading it in the paper guide.

4-1