Fujitsu ScanSnap S500 Memulai - Halaman 7
Jelajahi secara online atau unduh pdf Memulai untuk Printer Fujitsu ScanSnap S500. Fujitsu ScanSnap S500 25 halaman. Color image scanner
Juga untuk Fujitsu ScanSnap S500: Prosedur Instalasi (3 halaman), Brosur & Spesifikasi (2 halaman), Petunjuk Pembersihan (2 halaman)
Halaman Cetak
1. Preparation
This chapter describes necessary preparations before using
ScanSnap.
Do not connect the scanner to your PC
before installing "ScanSnap Manager".
If the scanner is connected before installing
ScanSnap Manager, it will not operate
correctly.
Refer to Chapter 2 for the installation of
ScanSnap Manager.
1.1. Checking the Contents of the
Package
When you unpack the scanner package, make sure that all
parts are included.
Refer to the package contents list included the scanner
package box.
1.2. Names and Functions of Parts
This section describes the names and functions of parts.
Front Side
Paper chute cover
Open this cover when using
the scanner.
→ Opening the cover turns the
scanner ON.
Cover open lever
Pull this lever to open the ADF cover.
Paper chute cover
Open this cover and load the documents
onto this part when scanning documents.
Side guide
Adjust these guides to the documents
width for preventing skewed
ADF cover
(ADF: Automatic Document
Feeder)
Stacker
For using this part, pull it out
as shown in the figure.
→ Documents are ejected from the ADF onto this tray.
Buttons
Rear Side
USB connector
HINT
Buttons
[SCAN] button
Starts scanning.
[POWER] button
Turns on/off the power supply.
SCAN
POWER
Power lamp
Indicates the scanner status.
Blue
Blue (Blinking)
Orange
Light off
AC adapter connector
Seal: After installing ScanSnap Manager onto
your computer, remove this seal to connect the
scanner to the PC.
For the Document Specification, refer to the
"ScanSnap S500 Operator's Guide" stored
in ScanSnap Setup CD-ROM.
The scanner is turned on/off automatically, when
you open/close the Paper chute cover.
To turn off the scanner when the cover is opened,
press the [POWER] button.
ScanSnap S500 Getting Started | 5
:Ready
:Scanning
:Error
:Power off