Brother ADS-1100W Panduan Pengaturan Cepat - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pemindai Brother ADS-1100W. Brother ADS-1100W 35 halaman.

For Wireless Network Users

ADS-1600W

Error Code

TS-01

TS-02

TS-03

TS-04

The wireless setting is not activated.

Turn the wireless setting to ON:

1. On your machine, press

2. When Enable WLAN? is displayed, press Yes.

This will start the wireless setup wizard.

The wireless access point/router cannot be detected.

1. Check the following:

- Make sure that the wireless access point/router is powered on.

- Move your machine to an obstruction-free area, or closer to the wireless access

point/router.

- Temporarily place your machine within about one metre of the wireless access point

when you are configuring the wireless settings.

- If your wireless access point/router is using MAC address filtering, confirm the MAC

address of the Brother machine is allowed in the filter.

2. If you manually entered the SSID and security information (SSID/authentication

method/encryption method/Network Key), the information may be incorrect.

Confirm the SSID and security information and re-enter the correct information as

necessary. See How can I find the wireless security information (SSID and Network

Key*) on page 13.

The wireless network and security setting you entered may be incorrect.

Confirm the wireless network settings. See How can I find the wireless security information

(SSID and Network Key*) on page 13.

Confirm that the entered or selected SSID/authentication method/encryption

method/UserID/Userpass are correct.

The Authentication/Encryption methods used by the selected wireless access point/router

are not supported by your machine.

For infrastructure mode, change the authentication and encryption methods of the wireless

access point/router. Your machine supports the following authentication methods:

Authentication Method

WPA-Personal

WPA2-Personal

Open

Shared key

If your problem is not solved, the SSID or network settings you entered may be incorrect.

Reconfirm the wireless network settings. See How can I find the wireless security

information (SSID and Network Key*) on page 13.

For ad-hoc mode, change the authentication and encryption methods of your computer for

the wireless setting. Your machine supports Open authentication method only, with optional

WEP encryption.