Brother ADS-1500W Panduan Pengaturan Cepat - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pemindai Brother ADS-1500W. Brother ADS-1500W 35 halaman.

Product Safety Guide

Regulation

WARNING

This product must be installed near an AC power outlet that is easily accessible. In case of an

emergency, you must unplug the power cord from the AC power outlet to shut off the power

completely.

IMPORTANT

• Brother cannot accept any financial or other responsibilities that may be the result of your use of this

information, including direct, special or consequential damages. There are no warranties extended or

granted by this document.

• This machine has been certified to comply with FCC standards, which are applied to the USA only.

Federal Communications Commission (FCC) Declaration of

Conformity (USA only)

Responsible Party:

declares, that the products

Product Name: ADS-1000W and ADS-1500W

comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

IMPORTANT

• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user's authority

to operate the equipment.

• A specific shielded interface cable should be used to ensure compliance with the limits for a Class B digital

device.

Wireless connection (Mexico only)

The operation of this equipment is subject to the following two conditions:

(1) it is possible that this equipment or device may not cause harmful interference, and (2) this equipment or device

must accept any interference, including interference that may cause undesired operation.

Brother International Corporation

200 Crossing Boulevard

Bridgewater, NJ 08807 USA

TEL: (908) 704-1700