Fujitsu CREMSON MODULAR STARTERKIT Panduan Pengguna - Halaman 22
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Motherboard Fujitsu CREMSON MODULAR STARTERKIT. Fujitsu CREMSON MODULAR STARTERKIT 36 halaman.
Halaman Cetak
Follow these steps to use the MB91360 Flash Programmer :
1. Be sure to have the starterkit in single-chip mode. Check the position of the Mode
DIP-switches onboard according to table1.
2. Connect the RS232-cable from your PC-COM-port to "UART0" (female UART
connector on the left side of the board).
3. Specify a (hex-)file in the "file to program"-field (use the browse-button to select).
This file must be a converted linker output file from Softune in the Motorola Hex-
Format "*.MHX" (for programming your own applications, be sure to have the load
module converter started in Softune Workbench to generate MHX-files !).
4. Select the appropriate device type "MB91F365,6,7,8,9Gx" for the F369-board or
"MB91F362" for the F362-board
5. Select your COM-port (default is COM1) and any desired baudrate (default is 38400).
6. Make sure the CPU-module is switched off or in permanent reset. Now click on
Automatic Mode button and immediately switch on the starterkit (or release the reset)
to start the flash programming. The flash programming sequence will be executed
automatically.
7. CAUTION : DO NOT INTERRUPT THE FLASH PROGRAMMING OR CUT OFF THE
POWER DURING PROGRAMMING !
8. Wait until the programming sequence is finished.
9. After a successful programming procedure, press reset on the Starterkit and close
the program on the PC.
The Flash Programmer uses the internal Boot-ROM functions instead of the monitor
kernel for flash programming. See the MB91360 hardware manuals for details.
For more information and trouble shooting, see the „MB91360 Serial flash programmer
user's guide" (Flashprg.pdf) which is included in the installation.
Cremson Starterkit User Manual
Chapter 5 Flash Programming
- 22 -
© Fujitsu Microelectronics Europe GmbH