Fujitsu F2MC-8FX Series Panduan Pengoperasian - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Motherboard Fujitsu F2MC-8FX Series. Fujitsu F2MC-8FX Series 20 halaman. 8-bit microcontroller
Juga untuk Fujitsu F2MC-8FX Series: Catatan Aplikasi (12 halaman), Catatan Aplikasi (23 halaman), Setup Manual (18 halaman), Setup Manual (19 halaman), Setup Manual (30 halaman), Catatan Aplikasi (20 halaman), Catatan Aplikasi (21 halaman), Panduan Pengoperasian (21 halaman), Setup Manual (23 halaman), Panduan Pengguna (24 halaman), Setup Manual (17 halaman)

Halaman Cetak
Fujitsu F2MC-8FX Series Panduan Pengoperasian
■ Setting of the switch and jumper plug
The positions of the switch and jumper plug on the MCU board is shown in Figure 8, and specifica-
tions are shown in Table 3.
Switch/Jumper plug
Clock selector switch
Clock supervisor selector
switch
APB8 bus output selector
switch
C-pin selector switch
Clock input selector
switch
Product selector switch
LVD selector switch
Voltage selector switch
Sub clock selector
jumper plug
LVD2 detection voltage
selector jumper plug
Figure 8 Positions of switches and jumper plugs on the MCU board
Table 3 Switch and jumper plug settings
ON : Disable the sub clock
SW1-1
OFF : Enable the sub clock
ON : Enable the clock supervisor function
SW1-2
OFF : Disable the clock supervisor function
ON : Enable the APB8 bus
SW1-3
OFF : Disable the APB8 bus
ON : Connect the C pin to the on-board 0.1µF capacitor
SW1-4
OFF : Disconnect the C pin from the on-board 0.1µF capacitor
Select the main clock and sub clock source on the MCU board or on
SW2
the user system (See "■ Setting of the clock input selector switch
(SW2)").
Set this switch depending on the number of pins on the target MCU
SW3
to be used (See "■ Setting of the product selector switch (SW3)").
Select the low-voltage detection function.
LVD1 : LVD1 enabled
SW4
OFF
: LVD function disabled
LVD2 : LVD2 enabled
Select 5V or 3V supply for the operating voltage of the evaluation
MCU.
SW5
5V : 5V supply
3V : 3V supply
Select whether to use the sub clock.
S1
(See "■ Setting of the sub clock selector jumper plug (S1)").
Set the LVD2 detection voltage (See "■ Setting of the LVD2 detec-
S2
tion voltage selector jumper plug (S2)").
S2
GND VCC
5V
8
SW5
SW3
PRODUCT SELECT
ON
ON
SC5
SC6
1 2 3 4
1 2 3 4
SW2
SW1
1
S1
SC4
2
C
B
A
BGM
ADAPTER
Settings
3V
SW4
SC3
SC2
SC1
Shipment
setting
Jumper of
OFF
OFF
OFF
OFF
OFF
0
OFF
3V
B-C
LVD0
7