Fujitsu FLASH-CAN-48P Panduan Pengguna - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Motherboard Fujitsu FLASH-CAN-48P. Fujitsu FLASH-CAN-48P 33 halaman. F²mc-16lx family

4.2 Synchronous Mode

In order to program the Flash-ROM synchronously via Serial-I/O (SCI1) special software has

to be used, e.g. Fujitsu „FlashKit‟ Tool. This tool is not available free.

Please contact our Web Site in order to get more information about the FlashKit-Tool:

http://www.fme.gsdc.de/gsdc.htm: select  Tools  Programme  MCU FlashKit

A dedicated Flash programming socket (X17) is provided on the FLASH-CAN-48P board for

direct connection to the Fujitsu „FlashKit‟.

X17: Flash programming socket

Note:

Open Jumper JP1 and JP2 in order to disconnect UART1 from the RS232-Transceiver !

In case that the FlashKit-Tool is used, all Mode-settings will be done automatically by the

FlashKit. This means that all DIP-switch S2 has to be set to the "OFF" position.

When using the

FlashKit-Tool...

Please refer to the manual of the FlashKit for more information how to program a Flash-

device by the synchronous-serial mode.

Note:

In case that another Programming-Tool is used and the Mode-settings have to be done

manually then use the following configuration of DIP-switch S2 in order to select the

synchronous-serial Flash-programming mode:

synchronous

Boot-Mode

UG-900002-20

FLASH-CAN-48P

Chapter 4 Programming the internal Flash

P30 1

MD0 3

RST 5

SOT1 7

VCC 9

MD0 MD1 MD2 nc

- 22 -

2 P31

4 MD2

6 SIN1

8 SCK1

10 GND

P31 P30

P84 P83

P31 P30

P84 P83

OFF