Fujitsu MB2146-401 Catatan Aplikasi - Halaman 11

Jelajahi secara online atau unduh pdf Catatan Aplikasi untuk Motherboard Fujitsu MB2146-401. Fujitsu MB2146-401 23 halaman. F2mc-8fx family evaluation board
Juga untuk Fujitsu MB2146-401: Setup Manual (30 halaman), Panduan Pengoperasian (34 halaman)

Halaman Cetak
Fujitsu MB2146-401 Catatan Aplikasi

3.3.2 Jumper settings and switches on MCU board

Please set the following switches and jumpers on the MCU board
1. Set the clock selector switch (SW1-1) to OFF.
2. Set the clock supervisor selector switch (SW1-2) to OFF.
3. Set the APB8 bus output selector switch (SW1-3) to OFF.
4. Set the C-pin selector switch (SW1-4) to OFF.
5. Set the clock input selector switch (SW2) to OFF.
6. Set the product selector switch (SW3) according to table 2.
(set to 0: 100-pin package type for evaluation chip)
7. Set the LVD selector switch (SW4) to OFF (middle).
8. Set the power supply selector switch (SW5) to 3V or 5V.
9. Set the jumper plug S2 to LVD0 (right).
10. Set the jumper plug S1 (1+2) to CB.
11. Mount the main clock oscillator (refer chapter 3.3.3)
12. Mount the sub clock oscillator (refer chapter 3.3.3, not required)
6
1-4
12
Figure 7: switch and jumper setting on MCU board
© Fujitsu Microelectronics Europe GmbH
MB2146-09 – Installation Guide
Chapter 3 Setting up the Emulation System
9
- 11 -
8
7
5
11
10
MCU-AN-395002-E-V10