Indesit Ariston AQUALTIS 1600 Panduan Servis - Halaman 20

Jelajahi secara online atau unduh pdf Panduan Servis untuk Mesin cuci Indesit Ariston AQUALTIS 1600. Indesit Ariston AQUALTIS 1600 48 halaman.

5. TECHNICAL ASSISTANCE:

It is available only on models with LCD and Display interface.

Activation:

Power On + Start/Reset + 4th button at the lower part

for 6 seconds.

Deactivation:

Power On + Start/Reset

for 3 seconds.

5.2. AUTO TEST (TESTING / RUNNING_IN):

The Hardware Key permits the execution of the platform EVO II Auto Test program.

On the hardware key switches on a BLUE LED, indicating it is an EVO II washing machine. A flashing

RED led on the key (when it is connected with the appliance) indicates that the electronic board is

communicating with the hardware key. If the hardware key does not succeed in connecting with the

washing machine, the message "ERR" will flash on the display

Initial conditions to start Auto Test:

Washing machine without water in the tank.

2. Door closed.

3. Switch on the washing machine and fit the key on the suitable housing.

Remember that the Auto Test program activates the heater to warm up water and controls the spin;

so it is necessary to select a temperature higher than 30°C and not to exclude the spin.

To start the AUTO-TEST program, press and leave the button marked as AUTO-TEST. A sound-

signal will be given out and on the display will slide the writing "AUTO-TEST".

Auto Test sequence for Washing Machines and Washer Dryer

- Loading of wash solenoid valve for 10" ca.

- Loading of pre-wash solenoid valve for 10" ca.

- Loading of hot water solenoid valve for 10" ca (in machines equipped with this solenoid valve).

- Motor movement on both directions.

- Activation of the wash heater: warming up to the temperature of 30°C.

- Drain and spin.

Stop.

NOTICE!! If now the washing machine works correctly, but previously it has had a FAULT, it will not start up

the AUTO-TEST program, but such a FAULT will be surely shown on the display of the hardware key.

In this case, to start up the "Auto-test" program is necessary to remove the hardware key.

Service Manual

Aqualtis - 2005

Edition

2005.07.06

Language

English