Indesit WIXXL 86 Buklet Instruksi - Halaman 7

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Indesit WIXXL 86. Indesit WIXXL 86 48 halaman. Indesit washing machine instruction booklet

Halaman Cetak

Personalisations

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).

The temperature can be lowered, or even set to cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.

The maximum spin speeds for each programme are as follows:

Programmes

Maximum spin speed

Cotton

800 r.p.m.

Synthetics

800 r.p.m.

Wool

600 r.p.m.

Silk

The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting the symbol

The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed

for each programme.

Options

To enable an option:

1. press the button corresponding to the desired option, according to the table below.

2. the option is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding option cannot be selected for the

programme set.

Option

Effect

Delays the start of the

wash by up to 9

hours.

Delay Timer

For washing a smaller

load.

Mini Load

This option reduces

the amount of

creasing on fabrics,

making them easier

to iron.

Easy Iron

Increases the

efficiency of the rinse.

Extra Rinse

Tr9231gb_WIXXL86-Indesit.p65

Comments

Press the button repeatedly until the LED corresponding

to the delay is turned off.

The fifth time the button is pressed, the option will be

disabled.

N.B. Once you have pressed the Start/Reset button, the

delay can only be decreased if you wish to modify it.

In addition to reducing actual washing time, this option will

reduce water and energy consumption by up to 50%.

Note: You can reduce the amount of detergent you use

with this wash.

When this option is set, programmes 4, 5, 6 and 7 will end

with the laundry left to soak (Anti-crease) and the Rinse

cycle phase LED

- to conclude the cycle, press the START/RESET button.

- to run the draining cycle alone, set the knob to the

relative symbol

Recommended when the appliance has a full load or with

large quantities of detergent.

will flash.

and press the START/RESET button.

20/01/05, 14.39

Enabled with

programmes

All

1, 2, 3, 4, 5

Rinse cycle

3, 4, 5, 6, 7,

8, 9, 10,

Rinse cycle

1, 2, 3, 4, 5,

8, 9, 10, 12, 13

Rinse cycle