Indesit CTAA 55 NF UK Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kulkas Indesit CTAA 55 NF UK. Indesit CTAA 55 NF UK 9 halaman. Refrigerator-freezer
Juga untuk Indesit CTAA 55 NF UK: Petunjuk Instalasi dan Penggunaan Manual (8 halaman)

Halaman Cetak

Instructions for water dispenser

disassembly and cleaning

I. Disassembly

1.Remove all water from the tank at first.Take

out the water tank components "o"pull out

the water tank components in the direction of

45°of oblique upward by hands that are closely

attached on the two sides of the water tank

components, when the lower parts of water tank

components are separated from the water valve

components, the water tank components can be

taken out through horizontal movement (to the

direction of user);

2. Take down the sealing ring of water tank

II. Cleaning

1. To disassemble the water tank, water tank

cover, sealing ring and water valve;

2. Use cold or warm water to cleaning the

components of water dispenser.

3. Wipe it with dry cloth.

Attentions:

1. If the cleaning solution is used for cleaning

water dispenser, then it is suggested that, before

the water taking and drinking, the water shall be

drained to the amount of 5-6 cups after the water

tank is installed back, so as to avoid the residue

cleaning solution.

III. Installation

1. Installation of water valve components

The guiding boss on the water valve components

shall be in alignment with the guiding slot on the

base, and press it down in the direction of in the

direction of 45°of oblique downward by hands with

strength, until you may hear the sound of "lick".

2. Installation of water tank sealing ring

To install the sealing ring on the bottom of water

tank by hand, make sure that it is properly installed,

and the wrinkling and oblique installation and so on

shall be avoided.

3. Installation of water tank components

The hanging slot on the water tank components

shall be in alignment with the suspension loop

on the inner layer, and the sealing ring at the

bottom of water tank shall be in alignment

with the entrance of water value components,

and then insert them into the corresponding

positions in the direction of 45° of oblique

downward by hands.

Cleaning of water receiving tank

Use wet cloth to wipe it and then use the dry

cloth.