Indesit IDL 505 Panduan Instalasi dan Penggunaan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Penggunaan untuk Mesin pencuci piring Indesit IDL 505. Indesit IDL 505 17 halaman. Indesit dishwasher installation and use
Juga untuk Indesit IDL 505: Panduan Instalasi dan Penggunaan (17 halaman)

Halaman Cetak

Salt ......

Salt

The hardness of the water varies from place to place. If

hard water is used in the dishwasher, deposits will form on

the dishes and utensils.

The appliance is equipped with a special softener that uses

a salt specifically designed to eliminate lime and minerals

from the water.

Loading the Salt into the Softener

Always use salt intended

for use with dishwashers.

The salt container is

located beneath the

lower rack and should be

filled as follows:

1. Remove the lower rack

and then unscrew and

remove the cap from the

salt container;

2. If you are filling the

container for the first

time, fill it with water;

3. Place the end of the funnel (supplied) into the hole and

introduce about 2 kg of salt. It is normal for a small amount

of water to come out of the salt container.

4. Carefully screw the cap back on.

The salt container should be filled after about every

30 wash cycles.

Warning: To prevent rust from forming, we advise you to

load the salt before starting a wash cycle.

Adjusting Salt Consumption

The dishwasher is designed to allow for adjusting the

amount of salt consumed based

on the harness of the water

used. This is intended to

optimize and customize the

level of salt consumption so that

it remains at a minimum.

Your Local Water Board can

supply the degree of hardness

of the water

in your area.

To adjust salt consumption, pro-

ceed as follows:

1) Unscrew the cap from the salt container.

2) There is a ring on the container with an arrow on it (see

figure to the side), if necessary, rotate the ring in the anti-

clockwise direction from the "_" setting towards the "+"

sign, based on the hardness of the water being used.

It is recommended that adjustments be made in accord-

ance with the following schema:

Water Hardness

Clarke

°fH

mmol/l

degrees

0 - 14

0 - 17

0 -1,7

14 - 36

18 - 44

1,8 - 4,4

36 - 71

45 - 89 4,5 - 8,9

>71

> 89

> 8,9

Salt

Autono-

consu-

Selector

mption

position

(cycles\2-

(grams/-

kg)

cycle)

"-"

MED

"+"