Indesit DIM 732J K.A IX Panduan Petunjuk Pengoperasian - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Oven Indesit DIM 732J K.A IX. Indesit DIM 732J K.A IX 12 halaman.

Halaman Cetak

1. Cooking Modes,6

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out

any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external parts and the rubber seals

may be cleaned using a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for the removal of stubborn

stains. After cleaning, rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

• The inside of the oven should ideally be cleaned after each use, while it is

still lukewarm. Use hot water and detergent, then rinse well and dry with

a soft cloth. Do not use abrasive products.

• All accessories - with the exception of the sliding racks - can be washed

like everyday crockery, and are even dishwasher safe.

• We recommend that detergents are not sprayed directly onto the control

panel, but that a sponge is used instead.

! Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack. For more thorough cleaning purposes, the oven

door may be removed:

1. Open the oven door fully (see diagram);

2. Lift up and turn the small levers located on the two hinges (see diagram);

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged,

please contact your nearest Service Centre (see Assistance). We recommend

that the oven is not used until the seals have been replaced.

Grip the door on the two external sides and

close it approximately half way.Pull the door

towards you lifting it out of its seat (see

diagram).

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-

holder.

2. Remove the light bulb and replace it with

a similar one: Wattage 25 W, cap E 14.

3. Replace the glass cover (see diagram).

! Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

To assemble the sliding racks:

1. Remove the two frames, lifting them

away from the spacers A (see figure).

2. Choose which shelf to use with the

Left

Right guide

sliding rack. Paying attention to the

guide rail

rail

direction in which the sliding rack is to be

extracted, position joint B and then joint C

on the frame.

3. Secure the two frames with the guide

rails using the holes provided on the oven

walls (see diagram). The holes for the left

frame are situated at the top, while the

holes for the right frame are at the bottom.

4. Finally, fit the frames on the spacers A.

! Do not place the sliding racks in position 5.

! ATTENTION

WHEN USING THE MAIN OVEN

YOU MUST ENSURE THAT THE

BASE OF THE CAVITY IS NOT

COVERED WITH ALUMINUM

FOIL, UTENSIL OR ANY OTHER

FORM OF COVERING. FAILURE

TO DO THIS MAY RESULT IN

THE CAVITY BEING DAMAGED.