Indesit K6G20S/I Panduan Instalasi dan Penggunaan - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Penggunaan untuk Oven Indesit K6G20S/I. Indesit K6G20S/I 37 halaman. Indesit cooker user's manual k6g21s/i k6g20s/i
Juga untuk Indesit K6G20S/I: Panduan Petunjuk Pengoperasian (44 halaman)
Halaman Cetak
quickly from high to low.
d) Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting to different types of gas
In order to adapt the oven to a different type of gas with
respect to the gas for which it was manufactured (indi-
cated on the label), follow these simple steps:
a) Replacing the oven burner nozzle
· open the oven door fully
· pull out the sliding oven bottom
· unscrew the burner fastening screws
· remove screw "V" and then the oven burner;
· Unscrew the oven burner nozzle using the special
socket spanner for the nozzles, or a 7 mm socket span-
ner, and replace it with a nozzle suited to the new type
of gas (see Table 1).
Take particular care handling the spark plug wires
and the thermocouple pipes.
· Replace all the parts, following the steps described
above in the reverse order.
b) Minimum regulation of the gas oven burner with thermostat:
•
light the burner as described in the paragraph "the oven knob"
of the instruction booklet.
•
turn the knob to Max for about 10 minutes and then turn the
knob to the Min setting;
•
remove the knob;
•
regulate the screw positioned outside the thermostat pin
until the flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must
be screwed in to the bottom.
V
•
check that the burner does not turn off when you turn the
knob from Max to Min and and when you open and close
the oven door quickly.
Regulating the Primary Air for the Oven Burner
The oven burner do not need to be regulated in terms of
primary air.
Important
On completion of the operation, replace the old rating sticker
with one indicating the new type of gas used. This sticker is
available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary) from
the recommended pressure, it is necessary to fit a suitable
pressure regulator onto the inlet pipe in compliance with current
National Regulations relative to "regulators for channelled gas".
16