Indesit IS67G5PHX/UK Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Kompor Indesit IS67G5PHX/UK. Indesit IS67G5PHX/UK 21 halaman.

Halaman Cetak

Gas connection

The cooker should be connected to the gas-supply by a gas safe registered

installer. Connection of the appliance to the gas mains or liquid gas must be

carried out according to the prescribed regulation in force, and only after it

is ascertained that it is adaptable to the type of gas to be used. If not, follow

the instructions indicated in the paragraph headed "Adaptation to different

gas types". In the case of connection to liquid gas, by tank, use pressure

regulators that conform to the regulation in force. The gas supply must be

connected to the left of the appliance. Be sure that the hose does not pass

through the rear of the cooker touching hot parts.

Make sure the supply pressure conforms with the values shown in the table

entitled "Characteristics of the burners and nozzles".

When the cooker is installed between cabinets (recessed), the gas

connection must be effected by an approved flexible hose with bayonet

fitting (BS 669 or EN 14800). The gas inlet for the cookers is a threaded G 1/2

gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to

the current gas regulations which are:

• the hose must never be at any point in its length in contact with the "hot"

parts of the cooker;

• the hose must never be longer than 1,5 meter;

• the hose must not be subject to any tension or torsional stress and it

must not have any excessively narrow curves or bottlenecks;

• the hose must be easy to inspect along its entire length to check its

condition;

• the hose must always be in good condition, never attempt to repair.

Adapting the cooker to different types of gas:

It is possible to adapt the appliance to a type of gas other than

the default type (this is indicated on the rating label on the cover).

Adapting the hobs:

Replacing the nozzles for the hob burners:

1. Remove the hob grids and slide the burners

2. Unscrew the nozzles using a 7mm socket

Fig. A

3. Replace all the components by following the above instructions in reverse.

Adapting the hob burner's minimum setting::

1. Turn the tap to the minimum position.

2. Remove the knob and adjust the regulatory

screw, which is positioned inside or next to the

tap pin (see figure B), until the flame is small but

steady. If the appliance is connected to a liquid

gas supply, the bypass screw must be set to a

minimum.

3. While the burner is alight, quickly change the position of the knob from

minimum to maximum and vice versa several times, checking that the

flame is not extinguished.

Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

After adjusting the appliance so it may be used with a different type of gas,

replace the old rating label with anew one which corresponds to the new

type of gas (these labels are available from Authorized Technical

Assistance Centers).

Should the gas pressure used be different (or vary slightly) from the

recommended pressure, a suitable pressure regulator must be fitted to the

inlet hose in accordance with current standards EN 88-1 and EN 88-2

relating to "regulators for channeled gas".

off their seats.

spanner (see figure A) and replace them

with nozzles suited to the new type of gas

(see Burner and nozzle specifications table).

Fig.B