Indesit KD3G11/G Petunjuk Instalasi dan Penggunaan Manual - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Penggunaan Manual untuk Kompor Indesit KD3G11/G. Indesit KD3G11/G 26 halaman. 50cm free standing dual fuel cooker
Juga untuk Indesit KD3G11/G: Panduan Petunjuk Pengoperasian (24 halaman)
Halaman Cetak
Disposing of the appliance
When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the
plug body and dispose of it as described above.
Adapting the cooker to different types of gas
In order to adapt the cooker to a different type of gas with respect to the gas for which it was produced
(indicated on the label attached to the lid), follow these steps:
a) Replacing the burner nozzles on the hob:
remove the grids and slide the burners from their housings;
•
•
unscrew the nozzles using a 7 mm socket spanner, and replace them with nozzles for the new type of
gas (see table 1 "Burner and nozzle characteristics").
•
replace all the components by repeating the steps in reverse order.
b) Minimum regulation of the hob burners:
•
turn the tap to minimum;
•
remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the
flame is small but steady.
N.B.: in the case of liquid gas, the regulation screw must be screwed in to the bottom.
•
check that the flame does not turn off when you turn the tap quickly from high to low.
c) Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Important
On completion of the operation, replace the old rating sticker with one indicating the new type of gas used.
This sticker is available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary
to fit a suitable pressure regulator onto the inlet pipe in compliance with current National Regulations relati-
ve to "regulators for channelled gas".
6