Indesit IDCA 735 S Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengering Indesit IDCA 735 S. Indesit IDCA 735 S 16 halaman. Tumble dryer
Juga untuk Indesit IDCA 735 S: Buku Petunjuk (21 halaman), Buku Petunjuk (20 halaman), Buku Petunjuk (32 halaman)

Halaman Cetak

Care and maintenance

Disconnecting the power supply

! Disconnect the dryer when not in use or

during cleaning and maintenance operations.

Cleaning the filter after each

cycle

The filter is a fundamental component of the

dryer: its function is to collect lint and fluff that

seriously hampered: drying times becomes

loger and more energy is consumed. Moreover,

Picture).

2. Clean the fluff off the filter and replace it

correctly. Ensure that the filter is pushed fully

home.

! Do not use the dryer unless the filter has

been replaced in its holder.

Checking the drum after each cycle

Rotate the drum manually to remove smaller items (handker-

chiefs) that could have been left inside the dryer.

Cleaning the drum

Avoid using abrasives, steel wool or stainless steel cleaning

agents to clean the drum. A coloured film may appear on the

stainless steel drum surface: it may be caused by a combina-

tion of water and/or cleaning agents such as wash-softeners.

This coloured film does not affect the dryer's performance.

form during drying.

Clean the filter once

drying is completed, by

rinsing it under

running water or cleaning

it with a vacuum cleaner.

Should the filter become

clogged, the flow of air

inside the dryer will be

the dryer may become

damaged.

The filter is located in

front of the dryer seal

(see Picture).

Removing the filter:

1. Pull the filter's plastic

handle upwards (see

Emptying the water container after

each cycle

Remove the water container and

empty it into a sink or other

suitable drain outlet, then

replace it correctly.

Always check the water contai-

ner and empty it before starting

a new drying cycle.

-Failure to empty the water container may cause

the following:

- The dryer stops heating (thus the load may still be

damp at the end of the drying cycle).

- The "Empty water container" LED activates to

show that the water container is full.

Priming the Water Collection System

When your dryer is new, the Water Container will

not collect Water until the system is primed, this

will take 1 or 2 drying cycles. Once primed it will

collect Water during every cycle.

Cleaning the condenser unit.

•

Remove the condenser (see Picture

below) unit regularly (monthly) and clean off

any fluff deposits from the plates by rinsing it

with cold water running on the rear end of the

condenser.

Removing the condenser:

Disconnect the dryer from the power

supply and open the

door.

Open the

condeser cover (see

Picture below), unlock

the three catches by

turning them 90°

anti-clockwise, then pull

on the grip to remove

the condenser.

Clean the surface

of the seals and replace

the unit with the arrows

pointing upwards, while

making sure that the

catches are securely

fixed.