AEG A 40270 GT Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku AEG A 40270 GT. AEG A 40270 GT 8 halaman. Electrolux freezer user manual

AEG A 40270 GT Panduan Pengguna

Safety Information

Before installing and using the appliance read this user's
instruction book carefully. It contains safety precautions,
hints, information and ideas. If the freezer is used in
compliance with these instructions, it will operate properly
and provide you with the greatest satisfaction.
These warnings are provided in the interest of safety. You
must read them carefully before installing or using the
appliance.
Use the freezer only for storing frozen food, freezing
fresh food and making ice cubes.
Do not eat ice cubes or ice lollies immediately after
taking them out of the freezer, as they may cause frost
burns.
Do not allow children to play or hide inside the freezer,
as they may become trapped inside and suffocate.
Do not store glass containers with liquids in the freezer,
as they may burst.
Ensure that the freezer is not resting on the power
supply cable.
Before servicing or cleaning, always unplug the
appliance or disconnect the power supply.
Do not use other electrical appliances (such as ice
cream makers) inside the appliance.
Your appliance contains an environmentally friendly
natural gas, isobuthane (R600a). Caution is required
however, since isobuthane is flammable. Therefore it is
essential to ensure that the refrigerant pipelines are not
damaged.
It is most important that this instruction book should be
retained with the appliance for future reference.

Product Description

8
9
7
6
4
1
5
2
1. Lid handle
2. Security lock
3. Seal
4. Defrost water drain

5. Control panel

6. Thermostat knob: temperature adjustment
7. Upper edge
8. Light
9. Valve: easy re-opening of lid
Control panel
A. Red light: Illuminates when the freezer temperature is
not sufficiently low.
B. Green light: Illuminates when the appliance is on.
C. Yellow light: Illuminates when the Super Freeze
function is activated.
D. Super Freeze button: Activates/deactivates the Super
Freeze function for large quantities for fresh food and
switches off the beeping alarm.

Installation

Wait at least 2 hours before connecting the freezer to
the power supply to ensure the refrigerant circuit is fully
efficient.
Install the freezer in a dry, well ventilated room. Avoid
locations near a source of heat or in direct sunlight.
The room temperature should correspond to the
climatic classification for which the freezer was
designed, see chapter "Technical data".
3
Place the freezer horizontally on a firm surface, resting
on all four feet.
For optimum operation and in order to avoid damage
when the lid is opened, leave a space of at least 5 cm
from the rear wall and 5 cm at the sides.
Before connecting the freezer to the power supply,
ensure that the voltage corresponds to that indicated in
chapter "Technical data" under "Voltage".
Danger!
Ensure that the freezer is not resting on the power
supply cable.
Do not remove the power supply cable by pulling on its
lead, particularly when the freezer is being pulled out
of its niche.
The power supply cable may only be replaced by a
qualified electrician.
Ensure that the power plug is not squashed or
damaged by the back of the freezer.
3