Indesit IDV 65 Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengering Indesit IDV 65. Indesit IDV 65 16 halaman. Indesit clothes dryer user manual
Juga untuk Indesit IDV 65: Buku Petunjuk (17 halaman), Buku Petunjuk (16 halaman), Buku Petunjuk (16 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (16 halaman), Buku Petunjuk (10 halaman)

Halaman Cetak

Electrical connections

Before plugging the appliance into the socket, check the following:

• Make sure your hands are dry.

• The socket must have an earth connection.

• The socket must be able to withstand the machine's ma-

ximum power output as indicated on the rating plate (see

Description of the tumble dryer).

• The power supply voltage must fall within the values indica-

ted on the data plate (see Description of the tumble dryer).

• The socket must be compatible with the dryer's plug.

Should this not be the case, replace the plug or the socket.

Do not use extension cords.

The dryer must not be installed outdoors, even if the space is

sheltered. It can be very dangerous if exposed to rain or storms.

Once installed, the dryer's electrical wire and plug must be

within reach.

The power cord must not be bent or squashed.

The power cord is supplied fitted with a BS1363 plug and with

a 13 amp BS1362 fuse. If it is necessary to fit a replacement

fuse, it must be a 13 Amp ASTA approved to BS1362 type.

WARNING: The plug must not be used without a fuse cover. If a

replacement fuse holder/cover is required, it must be of the same

colour coding or wording as shown on the base of the plug.

Replacements are available from authorised dealers.

Moulded plug

Changing the plug

The wires in the power cord are coloured in accordance with

the following.

Green and Yellow (Earth)

wire to terminal marked

"E", symbol x, or coloured

GREEN &

green and yellow.

YELLOW

BROWN

Blue (Neutral) wire to

BLUE

terminal marked "N" or

coloured black.

If the plug being replaced is a non-rewirable type, then the

cut-off plug must be disposed of safely. DO NOT leave it where

it can be inserted into a socket and create a shock hazard.

The power cord should be checked periodically and replaced

by a cord specially prepared for this dryer and fitted only by

authorized technicians (see Service). New or longer power

cords are supplied at an extra charge by authorized dealers.

The manufacturer denies any responsibility should any of

these rules not be followed.

If in doubt about any of the above consult a qualified

electrician.

Preliminary information

Once the tumble dryer is installed, clean the inside of the

drum before operating it and remove any dirt accumulated

during transportation.

13A ASTA approved fuse

to BS 1362.

13 ampere fuse

Brown (live) wire to

teminal marked "L" or

CROSS-BAR

coloured red.

CORD GRIP

Levelling the tumble dryer

The tumble dryer should be installed level in order to

operate correctly.

After installing the tumble

dryer in its permanent

position, make sure it is level;

check its side-to-side levelling

first, followed by front-to-

back.

If the tumble dryer is not

perfectly level, use a wooden

block to support it while you

adjust the two front feet, up or

down as necessary.

Before you start your dryer

Once the tumble dryer is installed, clean the inside of the

drum before operating it and remove any dirt accumulated

during transportation.