A-Neuvideo ANI-1201HD Buku Petunjuk - Halaman 14
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Beralih A-Neuvideo ANI-1201HD. A-Neuvideo ANI-1201HD 16 halaman. 12 input multi format video switcher
with hdbase-t, vga and hdmi outputs
Juga untuk A-Neuvideo ANI-1201HD: Buku Petunjuk (17 halaman)
Halaman Cetak
A
NEUVIDEO
The TP port of ANI-1201HD is used for TCP/IP control. Below is the introduction of TCP/IP control. The ANI-1201HD does not have a
build-in webserver for control. The TCP/IP connection requires you either send comments manually or from a third-party controller.
IP Configuration
1. Connect a computer to the TP port, set its IP to the same IP section as the default IP of
ANI-1201HD (192.168.0.178).
Same IP section but cannot
be 192.168.0.178
Figure 4: TCP/IP Setup
2. Enter 192.168.0.178 in your web browser, you should see the LOGIN page.
Figure 5: TCP/IP Login Screen
3. Enter the password "88888", you will be presented with "IPort Configuration Web Server"
page. From this page, you can manage system settings like IP address, IP reset, PW reset
etc. See Figure 6: TCP/IP IPort Configuration Web Server
Note: Serial configuration is fixed and cannot be changed.
Figure 6: TCP/IP IPort Configuration Web Server
After configuration, reset the device, then you can use the new IP address for controlling.
a. Connection and Command Control
1. Connect a computer and ANI-1201HD to the same network. Open the NET software
(or any other TCP/IP communication software) and create a connection, enter the IP
address and port of ANI-1201HD (default IP: 192.168.0.178, port:4001):
Figure 7: Connection and Command Control
2. After successful connection; you can enter commands to control the ANI-1201HD.
Figure 8: commands to control via TCP/IP
12