AEG ARCTIS Panduan Petunjuk Pengoperasian - Halaman 32

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pembeku AEG ARCTIS. AEG ARCTIS 36 halaman. Built-in fridge-freezers
Juga untuk AEG ARCTIS: Panduan Petunjuk Pengoperasian (32 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (28 halaman), Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Pengoperasian (36 halaman), Panduan Petunjuk Pengoperasian (36 halaman), Panduan Petunjuk Pengoperasian (26 halaman), Petunjuk Pengoperasian & Panduan Pemasangan (28 halaman), Panduan Petunjuk Pengoperasian (27 halaman), Panduan Petunjuk Pengoperasian (34 halaman), Panduan Pengguna (24 halaman), Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Pengoperasian (29 halaman), Panduan Petunjuk Pengoperasian (23 halaman), Panduan Petunjuk Instalasi (25 halaman), Panduan Petunjuk Instalasi (24 halaman)

Halaman Cetak
AEG ARCTIS Panduan Petunjuk Pengoperasian
What to do if ...
Symptom
Interior illumination does
not function.
The freezer compartment
temperature is insufficient.
Large accumulation of
frost in the appliance,
perhaps also at the door
seal.
Interior lighting does not
switch off when the door is
closed.
Unusual noises.
The compressor does not
start immediately after
pressing the FROSTMATIC
button, or after changing
the temperature setting.
32
Possible cause
Light bulb is defective.
Temperature is not properly
adjusted.
Door was open for a long
time.
Within the last 24 hours a
large quantity of warm
foods were loaded.
Appliance is next to a
source of warmth.
Door is not properly sealed
(perhaps after re-hanging
door).
Door contact maker is
wrongly adjusted.
Appliance is not level.
Appliance is in contact
with wall or other objects.
A part at the back of the
appliance, e.g. a tube, is in
contact with another
appliance part or the wall.
This is normal, no error has
occurred.
Solution
Please refer in this chapter
under "Replace light bulb" .
Please refer to the section
"Temperature Adjustment".
Only leave the door open
as long as necessary.
Press FROSTMATIC button.
Please refer to the section
"Installation Location".
Carefully warm the door
seal with a hand-held hair
dryer at those points which
are not airtight (no warmer
than approx. 50°C). At the
same time, shape the war-
med door seal by hand, so
that it is again properly
seated.
Please inform customer
service
Readjust the front levelling
feet.
Push appliance away a
short distance.
Bend this part away care-
fully if necessary.
The compressor starts after
a period of time.