AEG 2060 D Petunjuk Pengoperasian dan Pemasangan - Halaman 17
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kap Ventilasi AEG 2060 D. AEG 2060 D 20 halaman. Electrolux cooker hood operating and installation instructions 2060 d
Juga untuk AEG 2060 D: Panduan Pengoperasian dan Instalasi (19 halaman), Panduan Pengoperasian dan Instalasi (19 halaman)
Halaman Cetak
Wall unit mounting - Fig. 6
• Position the template (1) on the wall and mark the position, and drill
(2) the holes (2 x Ø 8 mm).
• Mount the two rawl plugs with the hooks (3).
• Hang the hood on the hooks and level it with the adjustment screws
(4).
• Remove the grease filters (5) and mark for the two screws (6).
Remove the hood and drill the holes (2 x Ø 8 mm).
• Insert the rawl plugs (7) and hang the hood on the wall again. Adjust
it horizontally with the screws (8) and secure it with the screws (9).
• Mount the chimney holder (10) with the rawl plugs (9) and the
screws (11).
Be careful that it is centered over the hood and horizontally aligned.
• Fitting for extractor version (S): Connect a tube between the
hood air outlet and the wall or roof exhaust channel. Note that the
top part of the chimney can be mounted with the side grids up or
down. For use as an extractor version hood it must be mounted with
the grids downwards.
Fitting for filter version (K): Mount the deflector (12) with the two
screws (13) supplied.
• Make electrical connection (14) (see paragraph "Electrical
connection")
• Place the chimney (15) and fix it to the top chimney holder with the
two screws (16) supplied.
Lower the bottom part of the chimney and fasten it to the top of the
hood with two screws (17), supplied.
Note that the top part of the chimney can be mounted with the side
grids up or down. For use as a recirculation hood it must be
mounted with the grids upwards.
17