AEG CHDD 8694 Petunjuk Pengoperasian dan Pemasangan - Halaman 18

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kap Ventilasi AEG CHDD 8694. AEG CHDD 8694 20 halaman. Cooker hood
Juga untuk AEG CHDD 8694: Petunjuk Pengoperasian dan Pemasangan (20 halaman), Petunjuk Pengoperasian dan Pemasangan (20 halaman)

Wall unit mounting - Fig. 7

• Mark the wall with a centre line, this will aid mounting procedure (1),

position the template so that the mid line printed on the template

matches with the centre line previously drawn, the lower side of the

template corresponds to the lower side of the hood once mounted

(2).

• Drill four holes Ø 8mm and fit four wall plugs (3).

• Drill two holes Ø 8mm on the upper side close to the ceilling (4) use

the chimney support as a template, check that the mid of the

chimney support corresponds to the mid of the centre line

previously drawn, fit two wall plugs.

Note: ONLY in case the hood is to be used in filter version, mount

the deflector E on the chimney support and the connection flange G

with two screws each (5).

• Fix the chimney support onto the wall with two screws and washers

(6).

• Hang the hood (7), remove the grease filters and fix it definitively

with two screws and washers (8), check that all four screws are

securely tightened.

• Fit an exhausting pipe (9) to connect the outlet hole D of the hood to

the connection flange G of the deflector E (Filter version) or to the

outside (Extractor version).

• Make electrical connection (10), but leave the hood disconnected

from the mains supply.

• Fix the circuit board and connection block unit on the top side of the

hood with two screws (boxes facing frontwards) (11).

• Place the cable clamp in the corresponding housing (12).

• Position the chimney and secure them in place, first up (13a) to the

chimney support (13b) , then slide it downwards making sure the

cable clamp (step 12) is seated in the housing on chimeny (14) and

that the control buttons match with the corresponding openings

(15).

• Adjust the position of the push-button box using two screws from

the inside of the motor housing (16).

• Fix the lower section of the chimney with two screws from the inside

of the hood (17).

• Refit the grease filters, connect the hood the the home general

electric panel and check if the hood work properly.