AEG CHDE3160-ML Petunjuk Pengoperasian dan Pemasangan - Halaman 17

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kap Ventilasi AEG CHDE3160-ML. AEG CHDE3160-ML 19 halaman.

• Fix the base spacer M to the wall with the two screws R 5x45

provided using either the long or the short arm, depending on the

depht of the side cupboards. Do not tighten the screws fully. Fig. 11.

• Fix the hood to the wall by means of the two hooks P

previously mounted, but first move the upper brackets S so

that the front panel of the hood, once mounted, will be in line

with the front edge of the cupboard doors. The two upper

brackets S, located at the top rear edge of the hood may be

slid backwards and forwards by loosening its fixing screws T

adjacent to them on the upper hood surface. Fig. 11.

• Check that the hood is at the right height. Minor height adjustments

may be made with the screws U embodied in the brackets. Fig. 11.

• Tighten the two wall fixing screws R, through the two access holes N

provided on the inside of the hood then fix the lower sliding frame to

the hood with two screws O and washers. Fig. 11.

Fixing a furniture door to the visor

Before fixing the furniture door to the visor, please ensure the distance

distance between the plate and the upper edge of the cabinet door is

correct (depends on the thickness of the material and whether or not

there is an upper shelf). Fig. 6.

= 17

16 = 33

19 = 36

• Remove the grease filters. Fig. 3.

• Take off the visor G by turning the rear locking knobs H. Fig. 13.

Fig. 12