Kohler 15343T Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Produk Pipa Kohler 15343T. Kohler 15343T 3 halaman. Shower head

Halaman Cetak

安装花洒头之前袁先打开水源冲洗

掉杂质遥

对于 12180T袁取出垫片(3)袁按图

示方向放入限流器(2-1)遥

对于 3867T袁安装限流器(2-2)和

垫片(3)遥

对于 15343T袁安装限流器(2-3)和

垫片(3)遥

在花洒臂(4袁客户自备)螺纹上缠

绕足以密封的密封胶带或涂适合

的密封胶袁用带状扳手将花洒头

(1)旋到花洒臂上遥

院若水压过低袁不需要安装限流

器遥水压超过 0.3Mpa渊3Bar冤袁花洒

必须安装限流器遥

喷孔杂质或结垢会导致水流变形袁

流量变小遥打开水源袁用力按压或

摩擦橡胶喷孔袁去除杂质或水垢遥

适用于所有加工处理过的表面院以中性肥皂水清

洗镀层表面袁再以干净的软布彻底擦干整个表面遥

许多清洁剂袁比如氨水尧去污粉及洁厕灵等袁会对电

镀表面造成伤害袁切忌使用遥

有磨损性的清洁用具或清洁剂也不可使用于科勒

牌的水龙头及其配件上遥

1075720-2-A

2-1

2-2

2-3

All Finishes: Clean the finish with mild soap and warm

water. Wipe entire surface completely dry with clean soft

cloth. Many cleaners may contain chemicals, such as

ammonia, chlorine, toilet cleaner etc. which could

adversely affect the finish and are not recommended for

cleaning.

Do not use abrasive cleaners or solvents on Kohler

faucets and fittings.

Flush both water supplies through the

shower arm(4, not provided) for about one

minute to remove debris thoroughly before

the installation.

For 12180T, take out the washer(3), put

the restrictor(2-1) into the ball joint as the

figure shown.

For 3867T, install the restrictor(2-2) and

the washer(3) into the ball joint.

For 15343T, install the restrictor(2-3) and

the washer(3) into the ball joint.

Apply enough tape or sealant to the threads

of the shower arm. Tighten the shower

head(1) with a strap wrench.

院 If the working pressure is too low,

the restrictor is not needed. Restrictor must

be installed if water pressure exceeds

0.3Mpa(3bar).

Any debris or mineral build-up may cause

the flow stream to become distorted or

reduce the flowrate. To remove the debris

or mineral build-up, run water through the

shower head, firmly press or rub your

finger back and forth across the rubber

nozzles.