AEG DD 8821 Petunjuk Pengoperasian dan Pemasangan - Halaman 19

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kap Ventilasi AEG DD 8821. AEG DD 8821 21 halaman. Aeg ventilation hood user manual
Juga untuk AEG DD 8821: Petunjuk Pengoperasian dan Pemasangan (21 halaman), Petunjuk Pengoperasian dan Pemasangan (23 halaman), Petunjuk Pengoperasian dan Pemasangan (21 halaman), Petunjuk Pengoperasian dan Pemasangan (21 halaman), Petunjuk Pengoperasian dan Pemasangan (21 halaman)

Mark the wall with a centre line, this will aid mounting procedure (1),

position the template so that the mid line printed on the template

matches with the centre line previously drawn, the lower side of the

template corresponds to the lower side of the hood once mounted

(2).

Drill two holes 0 8mm and fix the support bracket with two wall

plugs and screws (3). Hang the hood (4) and adjust its position (5-

6).

From the inside of the hood sign two points for definitive fixing (7).

Remove the hood (8) and drill two holes 0 8mm (9), fit two wall

plugs (10).

Drill two holes 0 8mm on the upper side close to the ceilling, fit two

wall plugs (11) (In case the hood is to be used in filter version,

mount the deflector F on the chimney support with four screws

2,9x6,5 (2 screws for hood model DD 8625-8821)) and fix the

chimney support G with two screws (12).

Hang the hood again (13) and fix it definitively with two screws (14).

Fit an exhausting pipe (15) to connect the outlet hole A of the hood

to the outside (Extractor hood) or to the deflector F (Filter version).

Make electrical connection (16).

Fix the chimney first up (17a) to the chimney support (17b), then

slide the lower section of the chimney down into the proper housing

on top of the hood (18).

Only for model DD 8625-8821: Fix the lower section to the hood

with two screws 3x9 mm (19).