AEG HC 3360 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kap Ventilasi AEG HC 3360. AEG HC 3360 20 halaman. Cooker hood
Juga untuk AEG HC 3360: Petunjuk Pengoperasian dan Pemasangan (25 halaman), Petunjuk Pengoperasian dan Pemasangan (25 halaman), Petunjuk Pengoperasian dan Pemasangan (24 halaman), Petunjuk Pengoperasian dan Pemasangan (25 halaman)

• When the hood is used in its extraction mode, the following rules

must be followed to obtain optimal operation:

- short and straight outlet hose

- keep bends in outlet hose to a minimum

- never install the hoses with an acute angle, they must always

follow a gentle curve.

- keep the hose as large as possible (preferably the same diameter

as the outlet hole).

- the length should be no more than:

3 metres with one 90° bend

2 metres with two 90° bends

Bends of more than 90° will reduce the efficiency of the hood and

reduce the airflow.

• Failure to observe these basic instructions will drastically reduce the

performance and increase the noise levels of the extractor hood.

Description of the Appliance

• The cooker hood is designed to extract unpleasant odours

from the kitchen, it will not extract steam.

• The hood is supplied as an extractor unit and can also be used with

a recirculation mode by fitting a charcoal filter.

• In some models the charcoal filter is supplied. The hood, therefore,

can be used immediately in the recirculation mode. We advise

removing the charcoal filter to use the hood in the extraction mode.

• In this mode fumes are extracted to the outside

via a hose connected to the coupling ring A.

Fig. 1.

• In order to obtain the best performance

the hose should have a diameter equal

to the outlet hole.

• Should there already be a pipe of

diameter 125 or 120 mm that ducts to

the outside through the walls, it is

possible to use the 150/125-120 mm

reduction flange provided. In this case

the hood will be slightly noisier.

Fig. 1