AEG mintie ECU4 Panduan Pemilik - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Kap Ventilasi AEG mintie ECU4. AEG mintie ECU4 17 halaman.

LOWERING/COLLAPSING THE ECU4 - AND STORING ENVELOPE IN PLACE

1. Grasp both height adjustment release levers located on each side of the ECU4 frame, depressing them with

your thumbs and pulling downward simultaneously and lower until unit reaches the floor. Do this on both

ends of the unit in succession. (Figs. III-1)

2. Detach ECU4 top edge of envelope from Velcro on Upper Folding Frame.

3. Detach all Velcro loops along corner posts from the floor up to the locking ring pulls sliders of ECU4 and floor

truss wraps. (Fig. III-3) Do not detach Velcro straps attached to ECU4 frame above the corner post sliders; these

remain in place for storage with the envelope in place.

4. Remove Upper Folding Frame by depressing both push pin latches, gently disengage short end of Upper

Folding Frame and pushing them inward toward each long side piece. (Figs. 12 next page detail).

5. Facing long side, grasp corners of Upper Folding Frame and lift upward. Repeat for second piece. Be

careful to avoid placing fingers, etc. between ends of short beams at center hinge points. (Figs. 12 next

page detail).

6. Disengage all four locking slider one at a time by pulling white Release Ring to release tension on unit. Slowly

push down the Slider just past where the Release Ring catches. (Figs 9. next page detail )

7. Remove the long side truss secure pins and place the long truss back into storage position securing them to

each corner post with push pins. (Review FIGs. 5 next page detail).

8. Pull release pins of the two end floor truss; and the frame is ready to articulate closed. (Fig 6 next page detail).

9. Face long side of ECU4, grasp two opposite corner posts above plastic sliders and slowly draw inward.

Do not grasp outer legs below sliders as this may result in pinched fingers. Be careful to not

force the Outer Legs together quickly, as the Upper Trusses may encounter excessive force as they

contact the collapsed ECU4 envelope. If you encounter any resistance when closing the unit, check

to confirm all four corner sliders have been disengaged as well as the Longside Lower Truss and that

the two Shortside Lower Trusses are raised at the center point off the floor.

10. Place the bottom most loop located closest to the floor at each corner and wrap around corner post above

locking corners (Fig,III-7). This will help distribute the envelope evenly for storage; pull some envelope to the

top before closing fully to avoid the bunching of envelope at the bottom. Wrap unit with Velcro belt, replace

the storage cover and put the top truss in the front pouch. (Figs. III-8)

(Figs. III-1 )

(Figs. III-7)

1-800-9MINTIE

(Fig. III-2 )

Leave Loops for storage

Figs. III-8)

1-323-225-4111

(Fig. III-3 )