Kohler BodySpa Panduan Pemilik - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Perlengkapan Kamar Mandi Kohler BodySpa. Kohler BodySpa 12 halaman. Module bathing system
C. USING YOUR WHIRLPOOL (IF EQUIPPED)
Refer to the chart at right for the proper operating
sequence.
1.
Close the drain, and fill the module basin with
tempered water to a level at least 2" above the
highest jets. Do not allow the water temperature to
exceed 104 F.
2.
Turn on the whirlpool by pressing the On/Off button
on the control switch located next to the module
soap ledge. Adjust each jet for optimum air/water
mixture.
3.
Use the and arrows to increase or decrease the
water force.
4.
A built-in heater automatically maintains the water
temperature while whirlpool bathing.
5.
Press the On/Off button a second time to turn off
the whirlpool.
6.
A built-in timer automatically stops the motor after
20 minutes of operation.
TE:
NO
The BodySpa and whirlpool functions will not
operate at the same time.
D. HELPFUL TIPS TO INCREASE ENJOYMENT
OF YOUR BODYSPA
S If you choose to use your BodySpa for more than
one 20-minute cycle, we suggest you open the door
for a moment between cycles. This will allow fresh
air to enter the enclosure.
S If you feel faint, drowsy, dizzy, or lightheaded at any
time, turn off your BodySpa and exit immediately.
S Only allow children to use your BodySpa if they are
supervised by an adult at all times. Do not allow
standing or jumping on the removable seat.
S To enhance your BodySpa experience, we suggest
you increase the water force gradually.
S There are six Body Jets positioned at an angle to
allow you to move in and out of the water spray to
concentrate your hydro-massage where you want.
The Body Jets are arranged in horizontal pairs to
create an effective hydro-massage pattern.
S Use the removable (optional) seat to enjoy your
hydro-massage experience from a sitting position.
Move the seat back and forth to focus the water
stream exactly where you want.
AA
114825-5-
(A)
TO
Turn on
whirlpool
massage and
the heater.
Decrease flow by
pressing
key;
increase flow by
pressing
key.
To add air and
Reduce
water to whirlpool
Air and
action, rotate the
Water
trim ringflange
counterclockwise.
To reduce air and
water, rotate it
clockwise.
Shut off whirlpool.
Restart whirlpool
after 20 minute
cycle is
complete.
8
METHOD
OBSERVE
Up/
More
Down/
Less
Add Air
and
Water
Kohler Co., Kohler WI