Kohler BodySpa K-1000 Panduan Petunjuk Instalasi - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Perlengkapan Kamar Mandi Kohler BodySpa K-1000. Kohler BodySpa K-1000 28 halaman. Tower custom hydro-massage system
Juga untuk Kohler BodySpa K-1000: Panduan Pemilik Rumah (48 halaman)
Halaman Cetak
K. ADJUST THE CENTER DOOR PANEL
Check if the center door panel hangs parallel with both
side door assemblies. Also check that the bottom
deflector just makes contact with the acrylic surface of the
footbath.
Loosen one or both roller nuts, and adjust the center door
panel by turning the cam roller with the wrench to obtain
proper fit. Tighten any loose roller nuts.
L. INSTALL THE BACKSTOP
Choose a backstop and cover to match the color of the
door frame.
Insert the well nut into the pre-drilled hole in the center of
the footbath curb.
Attach the backstop to the footbath curb by securely
threading a #10 x 1" panhead screw into the well nut. Do
not overtighten.
Apply silicone sealant to the backstop cap, then press it
onto the backstop.
M. INSTALL THE DOOR HANDLES
Fit the gasket over the groove in the side of the door panel.
Loosen the six handle clamp screws. Press the handle
over the gasket so the clamp and screws are on the inside.
Thread in one or two screws to temporarily hold the
handle in place. Note that the handle protrusion fits into
the groove in the glass panel. Slide the handle up or down
so the bumper flat rests on the footbath curb. Carefully
tighten all six screws. Use care to avoid stripping the
screws.
Repeat this procedure for the other handle.
Kohler Co., Kohler WI U.S.A.
Center Door Panel
#10 x 1" Panhead Screw
Apply
Sealant
Backstop
Cap
Handle
Bumper
Flat
17
Bottom Deflector
Backstop
Well Nut
Curb
Gasket
Handle
Clamp
Screws
Handle
Side Door Panel
Clamp
116290-2-
AB