Kohler Components EX28096K-4 Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perlengkapan Kamar Mandi Kohler Components EX28096K-4. Kohler Components EX28096K-4 2 halaman. Single control lavatory faucet - lever
Halaman Cetak
INSTALLATION
8
3
4
2
5
7
1
6
9
10
9
11
Chamfer Side Up
12
1483418-H2-A
How to Install the Faucet
If need to take off the hoses(1) to repair,
reinstall and tighten them by hand.
Install the mounting studs(2) into the
faucet(3) bottom. Slide the escutcheon(4)
over the hoses and mounting studs until
it is put into the faucet bottom.
Insert the faucet assembly into the hole
of the lavatory until the escutcheon
contacts the deck.
From underside of the lavatory, place the
washers(5, rubber washer is on the top)
onto the mounting studs. Position the
faucet．Tighten the nuts(7) with tool(6) to
secure the faucet.
Insert the lift rod(8) to the hole at the rear
of the faucet.
Attach the hoses to water supplies.
The hose with "COLD" label should be
connected to cold water.
How to Install the Drain
Install the waste(9) with foam ring(10) into
the drain hole.
Install the seal(11), secure and tighten the
drain body(12) to the waste by hand.
2
14
16
15
13
17
8
18
13
INSTALLATION CHECKOUT
20
22
19
21
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1483418-H2-A
Adjust the drain body to enable the ball
lever(13) and lift rod(8) to engage.
Insert the waste stopper kit(14) into the
waste.
Insert the ball lever into the drain body
and through the stopper hole(15).
Make sure that the ball lever engages
with the waste stopper kit and adjust the
waste stopper screw(16) if required.
Tighten the ball lever retaining nut(17)
by hand.
How to Install the Lift Rod Kit
Attach the connector(18) onto the ball
lever(13) and lift rod(8). Tighten the
connector retaining screw with a suitable
screwdriver.
Connect the drain body to the drain outlet.
Ensure all connections are tight.
Ensure the handle is in the off position.
Turn on the drain and main water supply,
and check for leaks. Repair as needed.
Uninstall the screw(20) with hex wrench
(19). Remove the aerator(22) with tool
(21). Turn on the faucet. Run hot and cold
water through the spout for about one
minute to remove any debris. Check for
leaks. Remove any debris from the
aerator. Shut off the faucet. Reinstall the
aerator. Tighten the screw.
3