AEG 9000 Series Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG 9000 Series. AEG 9000 Series 48 halaman.
Juga untuk AEG 9000 Series: Panduan Pengguna (32 halaman), Panduan Pengguna (8 halaman)

Halaman Cetak

7. BEFORE FIRST USE

During installation or before

first use you may observe

some water in the appliance.

This is a residual water left

in the appliance after a full

functional test in the factory

to ensure the appliance is

delivered to customers in

perfect working order and is

no cause for concern.

1. Make sure that all transit bolts have

been removed from the appliance.

2. Make sure that the electrical power is

available and the water tap is open.

3. Make sure that there is salt in the

compartment marked by

8. THE WATER SOFTENER (SOFTWATER

TECHNOLOGY)

8.1 Introduction

The water contains harsh minerals. The

higher the content of these minerals the

harder the water is.

Hard water can reduce the effectiveness

of the detergent, reduce the softness of

fabrics and contribute towards shrinkage

and colour fading.

This appliance is equipped with a water

softener able to provide the right degree

of water softening to preserve the fabric

integrity, colour brightness and ensuring

good wash performances at low

temperature.

The water softener should be adjusted

according to the water hardness of your

inlet water. A correct setting allows to

achieve the best washing results and the

maximum garments protection.

To set the water softener correctly,

please refer to 'How to set the water

hardness level'.

4. Pour 2 litres of water into the

This action activates the drain system.

5. Pour a small quantity of detergent

6. Set and start a programme for cotton

This removes all possible dirt from the

drum and the tub.

Salt

and set

8.2 How to set the water

hardness level

The appliance allows you to chose

between 7 levels corresponding to 7

different ranges of water hardness.

Depending on the country, the water

hardness is expressed in equivalent

scales: e.g. French degrees (°f), German

degrees (°d), English degrees (°e),

mmol/l and ppm.

If necessary, please contact your local

water authority to check the water

hardness in your area.

Check in the "Water hardness levels"

table which is the proper level.

To set the water hardness level:

1. Press the On/Off button for a few

2. Wait about 10 seconds for appliance

3. Touch the Stains/Prewash and the

the proper water hardness level.

Refer to "How to set the water

hardness level".

detergent compartment marked by

into the compartment marked by

at the highest temperature without

any laundry in the drum.

seconds to activate the appliance.

internal check.

Plus Steam buttons simultaneously

(by touching the two buttons at the

same instant, as shown in the next

drawing) for some seconds until the

display shows the default level C04

and the indicator

ENGLISH

goes on. It