Kohler K-1246 Panduan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perlengkapan Kamar Mandi Kohler K-1246. Kohler K-1246 48 halaman. Bath whirlpool
Juga untuk Kohler K-1246: Panduan Pemilik Rumah (32 halaman), Manual Pengasahan Awal (Roughing-In) (4 halaman), Manual Pengasahan Awal (Roughing-In) (4 halaman), Panduan Instalasi (44 halaman), Panduan Instalasi (48 halaman)

Kohler K-1246 Panduan Instalasi

10. Test Run the Whirlpool

Check all electrical connections, and make sure the electrical power to the whirlpool and heater (if
equipped) is on.
Make sure all union connections to the pump and heater are securely hand tightened.
Verify that the pump banding straps have been cut (if applicable), and that the pump is resting
directly on the subfloor or whirlpool base.
Fill the whirlpool to a level at least 2" (5.1 cm) above the top of the highest jet.
Operate the whirlpool for 5 minutes, and check all whirlpool piping connections for leaks.
For additional information on whirlpool operation, refer to "Confirm Proper Operation."

11. Complete the Finished Wall

If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Cover the framing with water-resistant wall material.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material.
Seal the joints between the whirlpool rim and the finished wall material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.

12. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
whirlpool surface. Use warm water and a liquid detergent to clean the surface.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods
of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire
brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild
abrasive action to any residual plaster.
1055820-2-A
Apply silicone sealant to the
Finished Deck
edges of the water-resistant
Material
deck material and the
finished deck.
Whirlpool
Drop-In Installation
Water-Resistant
Deck Material
Framing Material
12
Kohler Co.