AEG LAVATHERM 55370AH3 Panduan Pengguna - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG LAVATHERM 55370AH3. AEG LAVATHERM 55370AH3 24 halaman.
Halaman Cetak
14
www.aeg.com
9.7 Starting a programme
To start the programme:
Push the
The appliance starts and the LED above
the button does not flash but is stable.
9.8 Programme change
To change a programme:
1. Turn the programme dial to Stop
position.
2. Set a new programme.
9.9 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
10. HINTS AND TIPS
10.1 Ecological hints
• Spin good the laundry before drying.
• Use the load volumes which are
specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g.
with a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Make sure that is good airflow in the
appliance installation position.
Start/Pause button.
If the drying cycle is completed, the LED
above the
Start/Pause button flashes.
If the
Buzzer option is on, the
acoustic signal sounds intermittently for
1 minute.
If you do not turn off the
appliance, the crease guard
phase starts. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the
On/Off button for 2
seconds to turn off the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
10.2 Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1. Turn on the appliance.
2. Wait approximately 8 seconds.
3. Select 1 of available programmes.
4. Push at the same time and hold
down the
Reverse Plus and
Anti-crease buttons.
LEDs above the buttons are on.
5. Push the
Start/Pause button
again and again until you set
necessary degree.
The are 3 degrees available:
the indicator: Drying is on - the standard
dry laundry is set
the indicator: Cooling is on - the more
dry laundry is set