AEG LAVATHERM 59800 Informasi Pengguna - Halaman 22

Jelajahi secara online atau unduh pdf Informasi Pengguna untuk Pengering AEG LAVATHERM 59800. AEG LAVATHERM 59800 32 halaman. Aeg condenser dryer with heat pump
Juga untuk AEG LAVATHERM 59800: Informasi Pengguna (36 halaman)

Halaman Cetak

Problem

PROGRAMME TIME

display changes errati-

cally or stays un-

changed for a long

time.

Programme inactive,

EMPTY WATER display

illuminated.

Drying cycle ends

shortly after pro-

gramme starts. END

display illuminated.

Drying cycle lasts an

unusually long time.

Note:

After around 5 hours

the drying cycle ends

automatically (see

„Drying cycle com-

plete").

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The spe-

cial bulb can be obtained from the Customer Care Department, ET no.

112 552 000-5.

Important: When the appliance is switched on, the interior lighting

switches itself off after 5 minutes when the door is open.

Warning: Do not use standard bulbs! These develop too much heat and

may damage the appliance.

Warning: Before replacing the bulb, disconnect the mains plug; with a

permanent connection: fully unscrew or deactivate the fuse.

1. Unscrew cover above the bulb (this can be found directly behind the

loading aperture, at the top; refer to "Description of machine" section.)

2. Replace defective bulb.

3. Screw cover back down.

Warning: For safety reasons, the cover must be screwed down tightly.

If this is not done, the dryer must not be operated.

Possible cause

Programme time is correct-

ed automatically depending

on type and volume of

laundry and level of damp-

ness.

Condensate tank is full.

Not enough washing load-

ed or washing loaded is too

dry for selected programme.

Lint filter clogged.

Fluff filter clogged.

Load volume too big.

Laundry insufficiently spun.

Remedy

Automatic process; this is not

a machine fault.

Empty condensate tank, then

start programme with START/

PAUSE button.

Select time programme or

higher drying level (e.g. INTEN-

SIVE DRY instead of STORAGE

DRY).

Clean lint filter.

Clean fluff filter.

Reduce load volume.

Laundry must be adequately

spun.