AEG Lavatherm 76280AC Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG Lavatherm 76280AC. AEG Lavatherm 76280AC 28 halaman.
Juga untuk AEG Lavatherm 76280AC: Panduan Pengguna (36 halaman), Panduan Pengguna (24 halaman), Panduan Pengguna (28 halaman)

AEG Lavatherm 76280AC Panduan Pengguna
16
www.aeg.com
Buzzer option is activated, the acoustic
signal sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts. Laundry can be
removed during this phase.

11. HINTS AND TIPS

11.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programme chart.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
11.2 Adjustment of dryness
levels
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Push and hold down the Dry Plus
and Anti-crease buttons at the same
time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness

12. CARE AND CLEANING

12.1 Cleaning the filter
At the end of each cycle the indicator
Filter is on and you must clean the filter.
To remove the laundry:
1. Push the On/Off button for 2
seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
5. Push the Start/Pause button
repeatedly until you reach the
desired dryness level.
6. To set the new dryness level as the
default, push the Dry Plus and Anti-
crease buttons for approximately 2
seconds at the same time.
11.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Push and hold down the Dry Plus
and Buzzer buttons at the same
time.
One of 2 configurations is possible:
• the Tank indicator: is on if the
symbol
water container indicator is
permanently activated
• the Tank indicator: is off if the
symbol
water container indicator is
permanently deactivated
appears - the
appears - the