AEG LAVATHERM 7DBK73P Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG LAVATHERM 7DBK73P. AEG LAVATHERM 7DBK73P 24 halaman.

Halaman Cetak

www.aeg.com

• after you touch the Start/Pause

button - programs and option

selection is unavailable.

Child lock option activation:

1. Turn the dryer on.

2. Select 1 of the available programs.

3. Touch and hold down 2 buttons at

the same time.

The symbol

4. To deactivate the child lock, touch

the above buttons again until the

symbol disappears.

8.7 Starting a program

To start the program:

Touch the Start/Pause button.

9. HINTS AND TIPS

9.1 Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which

are specified in the programs chapter.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• Use distilled water like that used for

steam ironing. If it is necessary, clean

appears on the display.

The appliance starts and the LED above

the button stops flashing and stays on.

8.8 Program change

To change a program:

1. Push the On/Off button to turn the

appliance off.

2. Push the On/Off button again to turn

on the appliance.

3. Set a new program.

8.9 Program end

Clean the filter and drain the

water container after each

drying cycle. (See chapter

CARE AND CLEANING.)

If the drying cycle is finished, the symbol

appears on the display. If the Buzzer

option is activated, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the anti-crease

phase starts (not active with

all programs). Flashing

symbol signals the execution

of the anticrease phase.

Laundry can be removed

during this phase.

To remove the laundry:

1. Push the On/Off button for 2

seconds to turn the appliance off.

2. Open the appliance door.

3. Remove the laundry.

4. Close the appliance door.

the distilled water before (e.g. with a

coffee filter) to remove any particles.

• Always keep the airflow slots at the

bottom of the appliance clear.

• Make sure there is good airflow where

the appliance is to be installed.

9.2 Adjustment of default

dryness level

To change the default dryness level:

1. Turn the appliance on.