AEG LAVATHERM 8DBG84W Panduan Pengguna - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengering AEG LAVATHERM 8DBG84W. AEG LAVATHERM 8DBG84W 48 halaman.
Juga untuk AEG LAVATHERM 8DBG84W: Panduan Pengguna (48 halaman)
16
www.aeg.com
9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programs chapter.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use distilled water like that used for
steam ironing. If it is necessary, clean
the distilled water before (e.g. with a
coffee filter) to remove any particles.
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down the Dryness
(Droogtegraad) and Anticrease
(Anti-kreuk) buttons at the same
time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
4. Touch the Start/Pause (/Pauze)
button repeatedly until you reach the
desired dryness level.
Dryness lev-
el
Maximum
dryness
Display symbol
Dryness lev-
el
Extra dry-
ness
Standard
dryness
5. To memorise the setting touch and
hold down the Dryness
(Droogtegraad) and Anticrease
(Anti-kreuk) buttons at the same
time for approximately 2 seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Select 1 of the available programs.
3. Touch and hold down Anticrease
(Anti-kreuk) and Time (Tijd) buttons
at the same time.
One of 2 configurations is possible:
• the tank (reservoir) indicator:
on if the symbol
- the water container indicator is
permanently activated
• the tank (reservoir) indicator:
off if the symbol
- the water container indicator is
permanently deactivated
Display symbol
is
appears
is
appears